|
A) |
Manual-automatic down-feed unit, with adjustable feed increasing from .001 to 0,04 mm.(.00004 to .0016), and automatic stop at a stated value. |
|
B) |
Heavy duty grinding-motor 3 HP - 2800 RPM. |
|
C) |
The tilting head allows the grinding of hollow surfaces. |
|
D) |
The ways of the carriage are covered with hardened and ground replaceable strips. |
|
E) |
The knives-holding-chuck is made in cast-iron with mechanical clamping. Chuck-width 117 mm. (in. 4.6). |
|
F) |
Stepped-knives-holders for grinding 4 overlapped blades with locking clamps. |
| G) | The relative-drive of the work-table is tiltable through 100°. The degrees can be readable on a steel-rule, having two adjustable stops at 0° et 90°. |
| H) | variable advance speed (optional) carriage |
| I) | Motor of millstone 5 hp (optional) heavy duty grinding motor |
| J) | measurements 1780 mm x 520 mm x 150 mm overall sizes |
| .. | The magnetic
chuck is ideal to hold single blades, and it is also prepared to allow
the mechanical locking of the overlapped blades. Chuck-width 120mm. (in 4.7). Length 1000 mm. |
|
